Here are the step by step instructions for setting up a brand new Audiocodes
FXS gateway for use with an Asterisk server:
Connect the gateway to a network switch and connect a computer to the same
switch. Then configure the IP address of the computer to 10.1.10.2. Then run
your web browser and point it to http://10.1.10.10 and login using the
information below.
Default IP address: 10.1.10.10
Default user name: Admin
Default password: Admin
Goto "Quick Setup" and change the following:
IP Address => Set to the new IP address of the AudioCodes gateway
Subnet Mask => Set to the correct netmask for your local network
Default Gateway Address => Set to the correct gateway IP address for your
local network
Working With Proxy => Set to "Yes"
Proxy IP Address => Set to the IP address of the Asterisk server
Enable Registration => Set to "Enable"
Restart the gateway then log back in using the new IP address.
Goto Protocol Management -> Protocol Definition -> Proxy & Registration
Registrar IP Address => Set to the IP address of the Asterisk server
Registration Time => Set to "60"
Subscription Mode => Set to "Per Endpoint"
Authentication Mode => Set to "Per Endpoint"
Goto Protocol Management -> Protocol Definition -> DTMF & Dialing
Max Digits In Phone Num => Set to a large enough number such as "32"
Goto Protocol Management -> Protocol Definition -> Coders
Add coders as needed You need to set at least G.711U-law
Goto Protocol Management -> Endpoint Settings -> Authentication
Set SIP username and password for each port
Goto Protocol Management -> Endpoint Phone Numbers
Enter an extension (phone) number for every used channel
Your AudioCodes gateway is now ready.
../Arun
[EMAIL PROTECTED]
www.intelegentnetworks.com
On 6/27/06, Mark Adams <[EMAIL PROTECTED]
> wrote:
Hello,
Anyone here have experience with Audiocodes MediaPack MP-108 Gateways?
I would be willing to pay someone for advice and support with configuring my gateways for a telemarketing project I am starting. My experience is somewhat limited but all I want to do is make outbound calls just like I would on normal pots lines. (That's the best way to explain it) I do not need any special configuration nor am I going to use it for any incoming calls. I would like to just have the gateways register and properly send calls out and relay DTMF tones. After I get them up and running I should have the manual read and digested by then and I will be good to go.
Anyone interested please email me off list
Mark Adams
Infinity Marketing
216-334-9304
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
