http://qa.mandrakesoft.com/show_bug.cgi?id=5659
------- Additional Comments From [EMAIL PROTECTED] 2003-11-18 22:42 ------- I have a problem with identical symptoms - a complete freeze of the system. It occurs when I insert a, "integral 128MB USB 2.0 Flash Drive" into my laptop USB port. This worked fine with Mandrake 9.1. It also works fine with Knoppix 3.2 on the same system. Under Mandrake 9.2 (2.4.22-10mdk) it immediately freezes the whole laptop - the only thing I can do is power off and nothing is written to any logs. dmesg|grep -i usb usb.c: registered new driver usbdevfs usb.c: registered new driver hub usb-uhci.c: $Revision: 1.275 $ time 12:42:04 Sep 18 2003 usb-uhci.c: High bandwidth mode enabled usb-uhci.c: USB UHCI at I/O 0x1200, IRQ 11 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found usb-uhci.c: USB UHCI at I/O 0x1300, IRQ 10 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found usb-uhci.c: v1.275:USB Universal Host Controller Interface driver ehci_hcd 00:10.3: VIA Technologies, Inc. USB 2.0 usb.c: new USB bus registered, assigned bus number 3 ehci_hcd 00:10.3: USB 2.0 enabled, EHCI 1.00, driver 2003-Jun-19/2.4 hub.c: USB hub found usbdevfs: remount parameter error Modprobe gives no errors. -- Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: UNCONFIRMED creation_date: description: The computer freeze completly when I connect my Sony camera (see below for reference), this was not the behavior until the 9.1 mdk (must have start between 9.0 and the begining of cooker for the 9.1). Upgrade to 14/09/03 cooker uname -r returns : 2.4.22-0.1mdk modeprobe usb-storage is working fine USB system install : usb-uhci and ehci_hcd usb-uhci.c: v1.275:USB Universal Host Controller Interface driver ehci_hcd 00:1d.7: Intel Corp. 82801DB USB2 usb.c: new USB bus registered, assigned bus number 4 ehci_hcd 00:1d.7: USB 2.0 enabled, EHCI 1.00, driver 2003-Jun-19/2.4 hub.c: USB hub found Got installed SCSI with Adaptec 79xx card. Deep deep freeze of the computer at the connection (nor the magic keys or anything is working, just hard reset), no output on both message. Same equipment with mdk 9.0 ( and uname -r returns 2.4.19-16mdk) is working properly (just need to modeprobe and mount the usb storage).
