The register map for SM8150 QMP USB SSPHY has moved
QPHY_POWER_DOWN_CONTROL to a different offset.  Allow for
an offset in the register table to override default value
if it is a DP capable PHY.

Signed-off-by: Wesley Cheng <wch...@codeaurora.org>
Reviewed-by: Manu Gautam <mgau...@codeaurora.org>
---
 drivers/phy/qualcomm/phy-qcom-qmp.c | 23 +++++++++++++++++++----
 1 file changed, 19 insertions(+), 4 deletions(-)

diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c 
b/drivers/phy/qualcomm/phy-qcom-qmp.c
index d62bd09..dec4a17 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
@@ -119,6 +119,7 @@ enum qphy_reg_layout {
        QPHY_PCS_AUTONOMOUS_MODE_CTRL,
        QPHY_PCS_LFPS_RXTERM_IRQ_CLEAR,
        QPHY_PCS_LFPS_RXTERM_IRQ_STATUS,
+       QPHY_PCS_POWER_DOWN_CONTROL,
 };
 
 static const unsigned int msm8996_ufsphy_regs_layout[] = {
@@ -181,6 +182,7 @@ enum qphy_reg_layout {
        [QPHY_SW_RESET]                 = 0x00,
        [QPHY_START_CTRL]               = 0x44,
        [QPHY_PCS_STATUS]               = 0x14,
+       [QPHY_PCS_POWER_DOWN_CONTROL]   = 0x40,
 };
 
 static const unsigned int sdm845_ufsphy_regs_layout[] = {
@@ -2030,11 +2032,18 @@ static int qcom_qmp_phy_com_init(struct qmp_phy *qphy)
                             SW_USB3PHY_RESET_MUX | SW_USB3PHY_RESET);
        }
 
-       if (cfg->has_phy_com_ctrl)
+       if (cfg->has_phy_com_ctrl) {
                qphy_setbits(serdes, cfg->regs[QPHY_COM_POWER_DOWN_CONTROL],
                             SW_PWRDN);
-       else
-               qphy_setbits(pcs, QPHY_POWER_DOWN_CONTROL, cfg->pwrdn_ctrl);
+       } else {
+               if (cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL])
+                       qphy_setbits(pcs,
+                                       cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL],
+                                       cfg->pwrdn_ctrl);
+               else
+                       qphy_setbits(pcs, QPHY_POWER_DOWN_CONTROL,
+                                       cfg->pwrdn_ctrl);
+       }
 
        /* Serdes configuration */
        qcom_qmp_phy_configure(serdes, cfg->regs, cfg->serdes_tbl,
@@ -2260,7 +2269,13 @@ static int qcom_qmp_phy_disable(struct phy *phy)
        qphy_clrbits(qphy->pcs, cfg->regs[QPHY_START_CTRL], cfg->start_ctrl);
 
        /* Put PHY into POWER DOWN state: active low */
-       qphy_clrbits(qphy->pcs, QPHY_POWER_DOWN_CONTROL, cfg->pwrdn_ctrl);
+       if (cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL]) {
+               qphy_clrbits(qphy->pcs, cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL],
+                            cfg->pwrdn_ctrl);
+       } else {
+               qphy_clrbits(qphy->pcs, QPHY_POWER_DOWN_CONTROL,
+                               cfg->pwrdn_ctrl);
+       }
 
        if (cfg->has_lane_rst)
                reset_control_assert(qphy->lane_rst);
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

Reply via email to