Hey Ivan-

Nit below.

On Tue, Feb 18, 2014 at 03:21:20PM +0200, Ivan T. Ivanov wrote:
> From: "Ivan T. Ivanov" <iiva...@mm-sol.com>
> 
> Allows controller to be specified via device tree.
> Pass PHY phandle specified in DT to core driver.
> 
> Signed-off-by: Ivan T. Ivanov <iiva...@mm-sol.com>
> ---
>  drivers/usb/chipidea/ci_hdrc_msm.c |   23 ++++++++++++++++++++++-
>  1 file changed, 22 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/usb/chipidea/ci_hdrc_msm.c 
> b/drivers/usb/chipidea/ci_hdrc_msm.c
> index 2d51d85..3f67f1f 100644
> --- a/drivers/usb/chipidea/ci_hdrc_msm.c
> +++ b/drivers/usb/chipidea/ci_hdrc_msm.c
> @@ -57,9 +57,21 @@ static struct ci_hdrc_platform_data ci_hdrc_msm_platdata = 
> {
>  static int ci_hdrc_msm_probe(struct platform_device *pdev)
>  {
>       struct platform_device *plat_ci;
> +     struct usb_phy *phy;
>  
>       dev_dbg(&pdev->dev, "ci_hdrc_msm_probe\n");
>  
> +     /*
> +      * OTG(PHY) driver takes care of PHY initialization, clock management,
> +      * powering up VBUS, mapping of registers address space and power
> +      * management.
> +      */
> +     phy = devm_usb_get_phy_by_phandle(&pdev->dev, "usb-phy", 0);
> +     if (IS_ERR(phy))
> +             return PTR_ERR(phy);
> +
> +     ci_hdrc_msm_platdata.phy = phy;
> +
>       plat_ci = ci_hdrc_add_device(&pdev->dev,
>                               pdev->resource, pdev->num_resources,
>                               &ci_hdrc_msm_platdata);
> @@ -86,10 +98,19 @@ static int ci_hdrc_msm_remove(struct platform_device 
> *pdev)
>       return 0;
>  }
>  
> +static struct of_device_id msm_ci_dt_match[] = {

const?

> +     { .compatible = "qcom,ci-hdrc", },
> +     { }
> +};
> +MODULE_DEVICE_TABLE(of, msm_ci_dt_match);

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to