I can't seem to get mt CD-RW to work. I've tried Gnome Toaster, X-CDRoast and GCombust. Nothing seems to work. The drive works fine under Windows 2000 and I can record without problem. When I try it using cdrecord from the command line I get the following: ----------------------------------------------------- Cdrecord 1.10 (i586-mandrake-linux-gnu) Copyright (C) 1995-2001 Jörg Schilling TOC Type: 1 = CD-ROM scsidev: '0,0,0' scsibus: 0 target: 0 lun: 0 Linux sg driver version: 3.1.20 Using libscg version 'schily-0.5' atapi: 1 Device type : Removable CD-ROM Version : 0 Response Format: 1 Vendor_info : 'SONY ' Identifikation : 'CD-RW CRX700E ' Revision : '1.4h' Device seems to be: Generic mmc CD-RW. Using generic SCSI-3/mmc CD-R driver (mmc_cdr). Driver flags : SWABAUDIO Drive buf size : 8377856 = 8181 KB FIFO size : 4194304 = 4096 KB Track 01: data 650 MB Total size: 746 MB (73:59.06) = 332930 sectors Lout start: 747 MB (74:01/05) = 332930 sectors Current Secsize: 2048 ATIP info from disk: Indicated writing power: 4 Is not unrestricted Is not erasable Disk sub type: Medium Type A, high Beta category (A+) (3) ATIP start of lead in: -11079 (97:34/21) ATIP start of lead out: 359849 (79:59/74) Disk type: Long strategy type (Cyanine, AZO or similar) Manuf. index: 11 Manufacturer: Mitsubishi Chemical Corporation Trying to clear drive status. cdrecord: Drive needs to reload the media to return to proper status. Re-load disk and hit <CR> Blocks total: 359849 Blocks current: 359849 Blocks remaining: 26919 Starting to write CD/DVD at speed 4 in dummy mode for single session. Last chance to quit, starting dummy write in 0 seconds. Operation starts. Waiting for reader process to fill input buffer ... input buffer ready. cdrecord: Input/output error. read track info: scsi sendcmd: no error CDB: 52 01 00 00 00 FF 00 00 1C 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 05 00 00 00 00 12 00 00 00 00 24 00 00 C0 Sense Key: 0x5 Illegal Request, Segment 0 Sense Code: 0x24 Qual 0x00 (invalid field in cdb) Fru 0x0 Sense flags: Blk 0 (not valid) error refers to command part, bit ptr 0 (not valid) field ptr 0 cmd finished after 0.008s timeout 240s Writing time: 0.025s Fixating... WARNING: Some drives don't like fixation in dummy mode. Fixating time: 0.003s cdrecord: fifo had 64 puts and 0 gets. cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%. ------------------------------------------------------------------- Anyone have any ideas?
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
