Do you don't need of s4: SWITCHES="s1 s2 s3 s4 s5" s2_SLIRP=yes *- s4_SLIRP=yes (remove)*
VMS="end1 openflow1 openflow2 end2" end1_NETS=s1 end2_NETS=s5 openflow1_NETS="s1 *s2* s3" openflow2_NETS="s3 *s2* s5" end1_KERNEL=kernel.bin end2_KERNEL=kernel.bin openflow1_KERNEL=kernel.bin openflow2_KERNEL=kernel.bin ---- Carlos Macapuna www.macapuna.com.br On Tue, Nov 16, 2010 at 4:46 PM, Rohit Manohar <rdman...@ncsu.edu> wrote: > I am trying to build the following network topology in NOX > > > |----------| |------------------| > |-----------------| |----------| > | End1 |-----------| Openflow1 |----------------------------| Openflow2 > |---------| End 2 | > |----------| |------------------| > |-----------------| |----------| > > Both of the Openflow switches are connected to the Nox-Controller > > My .conf file is: > > SWITCHES="s1 s2 s3 s4 s5" > s2_SLIRP=yes > s4_SLIRP=yes > > VMS="end1 openflow1 openflow2 end2" > end1_NETS=s1 > end2_NETS=s5 > openflow1_NETS="s1 s2 s3" > openflow2_NETS="s3 s4 s5" > > end1_KERNEL=kernel.bin > end2_KERNEL=kernel.bin > openflow1_KERNEL=kernel.bin > openflow2_KERNEL=kernel.bin > > > Now, I have a few doubts > > 1. When I do dhclient on Openflow1 and Openflow2, both of them get the same > ip 10.0.2.15 on eth1. Is this right? Since they are different interfaces, > how can they use same IP? > > 2. How do I connect the two switches? > I am doing > ./dpctl addif nl:0 eth0 to connect Openflow1 to End1 > ./dpctl addif nl:1 eth0 to connect Openflow2 to End2 > > 3. Can pyswitch allow me to send packets from End1 to End2? > > Regards, > > -- > Rohit Manohar > Graduate Student > North Carolina State University > Raleigh, US. > > > _______________________________________________ > nox-dev mailing list > nox-dev@noxrepo.org > http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org > >
_______________________________________________ nox-dev mailing list nox-dev@noxrepo.org http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org