Hello, We are using the equipment "MUSTEK PowerMust 3000 NetGuard RM". That is using Megatec protocol. But unfortunately not all the data can be viewed correctly when dumping from utility "upsc".
For example: upsbox# upsc mus...@localhost battery.voltage: 108.00 battery.voltage.nominal: 96.0 driver.name: megatec driver.parameter.pollinterval: 2 driver.parameter.port: /dev/cuad0 driver.version: 2.4.1 driver.version.internal: 1.6 input.frequency: 50.0 input.frequency.nominal: 50.0 input.voltage: 227.0 input.voltage.fault: 227.0 input.voltage.maximum: 228.8 input.voltage.minimum: 224.1 input.voltage.nominal: 220.0 output.voltage: 227.0 ups.beeper.status: enabled ups.delay.shutdown: 0 ups.delay.start: 2 ups.load: 30.0 ups.mfr: unknown ups.model: unknown ups.serial: unknown ups.status: OL ups.temperature: 60.6 ups.type: standby Also when starting NUT program we can see the following messages: upsbox# /usr/local/etc/rc.d/nut start Network UPS Tools - UPS driver controller 2.4.1 Network UPS Tools - Megatec protocol driver 1.6 (2.4.1) Megatec protocol UPS detected. This UPS has an unsupported combination of battery voltage/number of batteries. Cannot calculate charge percentage for this UPS. Starting nut. As far as we understand this model of the equipment is not being supported currently. Could you please inform me who do I need refer to to add this equipment to the list of supported ones? And what kind of information regarding this equipment do you need from me? Thx for help. -- Best regards, IR12-RIPE RIV-UANIC _______________________________________________ Nut-upsuser mailing list Nut-upsuser@lists.alioth.debian.org http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
