On 02/13/2018 03:49 AM, Charles Lepple wrote:
On Feb 12, 2018, at 11:53 PM, David Melik wrote:
On 01/21/2018 05:53 AM, Charles Lepple wrote:
If you hook up a terminal emulator to the comms port (1200 baud, 8/N/1 unless stickers and/or
configuration DIP switches indicate otherwise), and type "f" <return>, do you
get a status line like one of the following?
https://github.com/networkupstools/nut/blob/v2.7.4/drivers/bestfcom.c#L226-L244
Of course, I got Eaton Powerware's RS-232 cable for FE700VA/etc. but don't know
what 'hook up a terminal emulator'... no Slackware GNU/Linux BASH command 'f,'
or do I run (or install/compile) a certain program to enable/access that?
minicom or screen should work - after you configure the serial port settings, they will
show everything sent by the UPS, and you can enter the "f" command in that
session.
For initial setup, you can run "minicom -s" and it takes you right to the
configuration screen. You will probably want to clear out some of the modem init strings
if they are present - the UPS will likely not understand them.
Minicom listed a blank modem init string, and 'f' did nothing. I didn't
see how to do anything similar in screen.
_______________________________________________
Nut-upsuser mailing list
Nut-upsuser@lists.alioth.debian.org
http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsuser
