[Nut-upsuser] Powercom SXL-1000A-LCD
Hi All! I have a traoble whith my ups, - megatec driver can not calculating % of charging and voltage on battery: # uname -a FreeBSD backup.*.*.* 8.1-RELEASE FreeBSD 8.1-RELEASE #0: Wed Sep 22 12:25:01 EEST 2010 ups.conf [Powercom] driver = megatec port = /dev/cuau0 #battvolts=12:24 desc = powercom sxl-1000A # ./nut start Network UPS Tools - UPS driver controller 2.4.1 Network UPS Tools - Megatec protocol driver 1.6 (2.4.1) Megatec protocol UPS detected. Cannot calculate charge percentage for this UPS. !!! Starting nut. Network UPS Tools upsd 2.4.1 listening on 172.16.0.220 port 3493 listening on 127.0.0.1 port 3493 Connected to UPS [Powercom]: megatec-Powercom Broadcast Message from ** (no tty) at 18:42 EET... Communications with UPS power...@localhost established # upsc power...@localhost battery.voltage: 2.30 !!! driver.name: megatec driver.parameter.pollinterval: 2 driver.parameter.port: /dev/cuau0 driver.version: 2.4.1 driver.version.internal: 1.6 input.frequency: 50.0 input.voltage: 231.0 input.voltage.fault: 231.0 input.voltage.maximum: 231.0 input.voltage.minimum: 228.0 output.voltage: 231.0 ups.beeper.status: disabled ups.delay.shutdown: 0 ups.delay.start: 2 ups.load: 74.0 ups.mfr: unknown ups.model: unknown ups.serial: unknown ups.status: OL ups.type: online Plise help! Sorry 4 my english! best regards! ___ Nut-upsuser mailing list Nut-upsuser@lists.alioth.debian.org http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
Re: [Nut-upsuser] Powercom SXL-1000A-LCD
Citeren ahouse-support supp...@ahouse.mine.nu: I have a traoble whith my ups, - megatec driver can not calculating % of charging and voltage on battery: You UPS doesn't report the battery charge, so that's not unusual. The megatec driver will guesstimate the battery charge based on the battery voltage, but this is very unreliable. [...] # ./nut start Network UPS Tools - UPS driver controller 2.4.1 Network UPS Tools - Megatec protocol driver 1.6 (2.4.1) Megatec protocol UPS detected. Cannot calculate charge percentage for this UPS. !!! [...] # upsc power...@localhost battery.voltage: 2.30 !!! See 'man 8 megatec' for answers how to fix the above two problems. Better yet, change to the 'blazer_ser' driver instead, which uses a better way to determine state of charge (based on a couple of parameters you need to provide). Make sure to read 'man 8 blazer' before returning here for help. Best regards, Arjen -- Please keep list traffic on the list (off-list replies will be rejected) ___ Nut-upsuser mailing list Nut-upsuser@lists.alioth.debian.org http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser