Thanks Bob for your advice.
I disconnected the ACC cable from the K4D and started it again. All OK this
time and the rig booted up normally showing Beta release 22 when clicking Fn>SW
List.
Many thanks Bob
73
Ray G3XLG
Sent from Mail for Windows
This will happen if K4 ACC Pin 8 (PWR ON) is being held to ground by
incorrect cabling to external devices.
Disconnect any cable from K4 ACC and the rig should power on and off and
reboot itself properly.
With proper cabling, no such disconnect is required to update the K4
firmware.
73,
Bob,
Ray …Are you posting your Request on the K4 Page ?
Ray WA6VAB K3
From: Ray Spreadbury via Elecraft
Sent: Sunday, August 29, 2021 1:09 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] New K4 beta software available release 22
Well I downloaded this new release and installed
Well I downloaded this new release and installed it as instructed on the
Elecraft Website. It reported SUCCESS after each module and then the K4D went
into a lock up with all 4 LED’s lit. After waiting 10 mins with no change, I
restarted the K4D with the same result – blank screen with all 4
Greetings,
Someone beat me to this, but here's the official word...release 22 is now
available as beta on our software downloads page. Upgrading is recommended in
order to remain current.
Release notes are listed below. They can also be found on our website, as well
as directly at the radio
5 matches
Mail list logo