:56 PM, Chris Jones wrote:
I have a raidz1 in degraded mode, with only 1 disk available. When I
try to boot it, I get this:
ZFS: can only boot from disk, mirror, raidz1, raidz2 and raidz3 vdevs
ZFS: i/o error - all block copies unavailable
ZFS: can't read MOS
ZFS: unexpected object set type 0
On 2/8/2012 12:42 PM, George Kontostanos wrote:
On Wed, Feb 8, 2012 at 6:03 PM, Chris Jonesch...@cjones.org wrote:
If you build a zfs in degraded mode, it's not bootable. But if you build it
normally, then remove a disk to put it in degraded mode, it is bootable.
I might be missing something
I have a raidz1 in degraded mode, with only 1 disk available. When I try
to boot it, I get this:
ZFS: can only boot from disk, mirror, raidz1, raidz2 and raidz3 vdevs
ZFS: i/o error - all block copies unavailable
ZFS: can't read MOS
ZFS: unexpected object set type 0
...followed by a couple of
/ad8s1a
I was copying from ad8 to gvinum volumes on ad10, and I was alternately
getting errors from ad8 or ad10, depending on whether I was using dump
or tar to do the copying. It appears to only happen under heavy disk
load, after 5-10 minutes.
Chris
Lowell Gilbert wrote:
Chris Jones ch
Lowell Gilbert wrote:
Chris Jones ch...@cjones.org writes:
# dump -0aL -f - /var | ( cd /mnt/var restore -rf - )
I got about a dozen messages like this:
DUMP: read error from /dev/ad8s1d: Bad address: [block 10992192]:
count=5120
It could be a serious problem
Hi folks--
I have an amd64 machine with two drives. I've got my system set up on
ad8, and I'm building a RAID0 array using gvinum that will span ad8 and
ad10. So for now, I have partitions on ad8 plus a set of volumes on ad10
that I want to move all my data to.
Today I was doing a test move
ugen0: O2 O2Micro CCID SC Reader, rev 1.10/1.10, addr 4
I'd appreciate any advice on getting my lost keystrokes back.
Chris
--
Chris Jones [EMAIL PROTECTED]www.cjones.org
PGP ID 5AFDD40A
___
freebsd-questions@freebsd.org
Hi. I've gone over list archives and seen this issue discussed before,
but the sugggested solutions aren't working for me. I am using
mpd-3.15_1 on FreeBSD 4.9-STABLE to connect to a Cisco 3000 Series VPN
Concentrator. I have negotiated CHAP and MPPE and the ng0 interface
comes up, but when I
when I try to send across
the tunnel.
Disabling encryption isn't an option, even for testing, I'm afraid.
Original message from Joe Marcus Clarke:
On Thu, 2004-01-08 at 02:49, Chris Jones wrote:
Hi. I've gone over list archives and seen this issue discussed before,
but the sugggested