[PATCH 2/2] net: pfe_eth: Remove non-DM code check from pfe_spi_flash_init

[Kuldeep Singh]

CONFIG_DM_SPI_FLASH is only supported now with passing of driver
conversion deadline from non-DM to DM model. Hence, it's safe to remove
non-DM code check from pfe_spi_flash_init.

Also use CONFIG_ENV_SPI_MODE and CONFIG_ENV_SPI_MAX_HZ instead of
reading reading values from DT.

Signed-off-by: Kuldeep Singh <kuldeep.si...@nxp.com>
---
 drivers/net/pfe_eth/pfe_firmware.c | 16 +++++-----------
 1 file changed, 5 insertions(+), 11 deletions(-)

diff --git a/drivers/net/pfe_eth/pfe_firmware.c 
b/drivers/net/pfe_eth/pfe_firmware.c
index 4ad09dd..d414c75 100644
--- a/drivers/net/pfe_eth/pfe_firmware.c
+++ b/drivers/net/pfe_eth/pfe_firmware.c
@@ -167,26 +167,20 @@ static int pfe_fit_check(void)
 int pfe_spi_flash_init(void)
 {
        struct spi_flash *pfe_flash;
+       struct udevice *new;
        int ret = 0;
        void *addr = malloc(CONFIG_SYS_QE_FMAN_FW_LENGTH);
 
        if (!addr)
                return -ENOMEM;
 
-#ifdef CONFIG_DM_SPI_FLASH
-       struct udevice *new;
-
-       /* speed and mode will be read from DT */
        ret = spi_flash_probe_bus_cs(CONFIG_ENV_SPI_BUS,
-                                    CONFIG_ENV_SPI_CS, 0, 0, &new);
+                                    CONFIG_ENV_SPI_CS,
+                                    CONFIG_ENV_SPI_MAX_HZ,
+                                    CONFIG_ENV_SPI_MODE,
+                                    &new);
 
        pfe_flash = dev_get_uclass_priv(new);
-#else
-       pfe_flash = spi_flash_probe(CONFIG_ENV_SPI_BUS,
-                                   CONFIG_ENV_SPI_CS,
-                                   CONFIG_ENV_SPI_MAX_HZ,
-                                   CONFIG_ENV_SPI_MODE);
-#endif
        if (!pfe_flash) {
                printf("SF: probe for pfe failed\n");
                free(addr);
-- 
2.7.4