I got something out of the Midiman Duo, but still not quite as good as under Windows:
If I use usb-uhci module for my USB controller, I get 2 PCMs, pcm0 supports recording at 44.1KHz (arecord -f cd), and works fine. pcm1 supports recording at 44.1KHz ok, and also at 48KHz, but when I try that, I get this in the log: usb-uhci.c: interrupt, status 2, frame# 1646 ALSA ../alsa-kernel/usb/usbaudio.c:628: timeout: still 5 active urbs.. usb_control/bulk_msg: timeout usb.c: USB disconnect on device 4 And after this I have no USB at all until reboot. USB mouse does not work, nothing. If instead I use uhci module, I get only one PCM, pcm0, and it supports 44.1KHz, and works fine. Why doesn't 48KHz work, and where are higher rates, where is 24bit recording? Thanks for any advice. -- Fedor G. Pikus Mentor Graphics Corporation | Phone: (503) 685-4857 8405 SW Boeckman Road | FAX: (503) 685-1239 Wilsonville, Oregon 97070 | http://www.pikus.net/~pikus/ ------------------------------------------------------- This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE! https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390 _______________________________________________ Alsa-user mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-user