2010/10/12 Bruno Randolf <b...@einfach.org>: > Hello! > > I am trying to debug a strange effect, I am seeing on soekris net48xx boards > with two ath5k interfaces: > > * wlan0 [phy0] configured in ad-hoc mode, A band, and it is getting a lot of > traffic routed thru it > * wlan1 [phy1] also configured in ad-hoc mode, G band, but not actively > sending (no IP address). > > I run iperf between two PCs attached by ethernet, UDP 25Mbps and I am sure all > traffic is routed thru wlan0 (phy0). The load on the SENDING box gets very > high: > > Mem: 27304K used, 99040K free, 0K shrd, 616K buff, 14128K cached > CPU: 0% usr 0% sys 0% nic 0% idle 0% io 5% irq 93% sirq > Load average: 1.73 1.01 2.23 2/38 3128 > PID PPID USER STAT VSZ %MEM %CPU COMMAND > 2772 2 root RW 0 0% 71% [phy1] > 2757 2 root SW 0 0% 11% [phy0] > 3128 436 root R 988 1% 8% top > 3 2 root SW 0 0% 5% [ksoftirqd/0] > 5 2 root SW 0 0% 3% [events/0] > 56 2 root SW 0 0% 1% [bdi-default] > 1383 1 root S 1824 1% 0% /usr/bin/oprofiled --session-dir=/r > > ...and the interesting thing is that [phy1] - the INACTIVE interface - > consumes much more CPU time than [phy0] which is actually transmitting. > > I have disabled ANI on wlan1, to avoid getting many MIB interrupts, but it > does not change much. > > I have dumped frames on phy1, and all it sees are a few beacon frames. > > I have tried wlan1 in managed mode - same effect. The effect is slightly less > in AP mode, though... > > I tried oprofile, but it shows mostly tx related things. > > So my question is: How can I find out, what [phy1] is so busy doing? Any ideas > how to profile this? > > Thanks in advance, > bruno >
When ph1 is also connected consumes more or less CPU ? What happens If you just give it an IP address ? -- GPG ID: 0xD21DB2DB As you read this post global entropy rises. Have Fun ;-) Nick _______________________________________________ ath5k-devel mailing list ath5k-devel@lists.ath5k.org https://lists.ath5k.org/mailman/listinfo/ath5k-devel
