Hi, I add some commands as u guys suggested:
Interesting things happened. from CCM to MC3810 when I make a call ,it would ring ( not a full ring ,just hear ringing for 0.5 sec) and then disconnected. from MC3810 FXS port to CCM ,I can call and ip phone ringing then when I pick up the ipphone ,nothing happens and from analogue phone prespective it seems no body picks up the ip phone on other side and keep hearing dial tone wait for other side to pick up , after couple of seconds I hear fast busy signal and both ends disconnected. So wired!!!!! ANy idea what's going on!!!? By the way I use 711 on ccm and 711 ulaw hardcoded to dial peer on IPIPGW/GK as u can see. Here are some changes I made AS U GUYS SUGGESTED: --- unchecked wait for media capabilities on MC3810: dial-peer voice 300 voip destination-pattern 3... session target ras dtmf-relay h245-alphanumeric ///this command added on IPIPGW/GK: telephony-service max-ephones 10 max-dn 10 sdspfarm units 1 sdspfarm transcode sessions 2 Cheers, On Sat, Oct 18, 2008 at 6:3 AM, James Key <[EMAIL PROTECTED]> wrote: > Jeremy, > > On your Gatekeeper controlled trunk, make sure that "Wait for Far End H.245 > Terminal Capabilities Set" is NOT checked. When an IPIPGW is involved, > everything has to be hardcoded and H.245 negotiation doesn't place nice with > IPIPGW in 12.4 mainline IOS. > > > > > > James > > > > > > *From:* [EMAIL PROTECTED] [mailto: > [EMAIL PROTECTED] *On Behalf Of *jeremy co > *Sent:* Friday, October 17, 2008 11:16 AM > *To:* ccie_voice@onlinestudylist.com > *Subject:* [OSL | CCIE_Voice] call disconnected after couple of > seconds,cannot hear any thing when picked up. > > > > Hi, > > > (3001) ipphone------CCM------HQ---IPIPGW/GK-----MC3810--FXS (2222) > > > CCM in IPIPGWCCMZONE zone > HQ in HQZONE > IPIPGW/GK in IPIPGWZONE > MC3810 in FXSZONE > > > I get no resource (47) disconnected cause code . > > When I remove " zone local FXSZONE abc.com invia IPIPGWZONE outvia > IPIPGWZONE enable-intrazone" from GK and replace it with " zone local > FXSZONE abc.com" > , basically removing ipipgw , every thing is fine and I can call from both > sides ,ccm and FXS port, but as soon as I add "invia IPIPGWZONE outvia > IPIPGWZONE enable-intrazone", > I can still call fraom both sides but when i pick up the phone I cannot > hear any thing and call will disconnected in couple of seconds. even if I > let phones ringing after couple of seconds it will disconnect. > > It sunds like codec problem but I believe some thing is wrong with ipipgw > config. > > Any idea? > > this is my scenario: > > > PIPGW/GK config : > > hostname C2600 > ! > frame-relay switching > isdn switch-type primary-ni > voice-card 1 > dsp services dspfarm > ! > ! > ! > ! > voice service voip > allow-connections h323 to h323 > ! > ! > ! > ! > ! > controller T1 1/0 > framing esf > clock source internal > linecode b8zs > pri-group timeslots 1-10,24 > ! > controller T1 1/1 > framing esf > clock source internal > linecode b8zs > pri-group timeslots 1-10,24 > ! > controller E1 1/2 > ds0-group 0 timeslots 1-2 type r2-digital r2-semi-compelled ani > ! > ! > interface Loopback0 > ip address 7.7.7.7 255.255.255.255 > ! > interface Loopback2 > ip address 2.2.2.2 255.255.255.0 > ip route-cache same-interface > h323-gateway voip interface > h323-gateway voip id IPIPGWZONE ipaddr 7.7.7.7 1719 > h323-gateway voip h323-id IPIPGW > > ! > interface FastEthernet0/0.200 > encapsulation dot1Q 200 > ip address 200.0.0.254 255.255.255.0 > ! > ! > mgcp > ! > sccp local FastEthernet0/0.200 > sccp ccm 142.4.64.11 identifier 1 > sccp > ! > sccp ccm group 1 > associate ccm 1 priority 1 > associate profile 1 register XCODER > ! > dspfarm profile 1 transcode > codec g711ulaw > codec g711alaw > codec g729ar8 > codec g729abr8 > codec g729r8 > codec g729br8 > maximum sessions 4 > associate application SCCP > ! > ! > dial-peer voice 30 pots > destination-pattern 01122443... > port 1/2:0 > forward-digits 8 > ! > dial-peer voice 200 pots > incoming called-number . > direct-inward-dial > port 1/2:0 > ! > dial-peer voice 600 voip > destination-pattern 2222 > session target ras > dtmf-relay h245-alphanumeric > codec g711ulaw > ! > dial-peer voice 601 voip > destination-pattern 3... > session target ras > dtmf-relay h245-alphanumeric > codec g711ulaw > ! > gateway > timer receive-rtp 1200 > ! > ! > ! > ! > gatekeeper > zone local CCMZONE abc.com 7.7.7.7 > zone local HQZONE abc.com > zone local IPIPGWCCMZONE abc.com > zone local IPIPGWZONE abc.com > zone local FXSZONE abc.com invia IPIPGWZONE outvia IPIPGWZONE > enable-intrazone > no zone subnet CCMZONE default enable > zone subnet CCMZONE 114.0.0.11/32 enable > zone subnet CCMZONE 114.0.0.12/32 enable > no zone subnet HQZONE 200.0.0.100/32 enable > zone subnet HQZONE 114.0.0.254/32 enable > zone subnet IPIPGWCCMZONE 114.0.0.11/32 enable > zone subnet IPIPGWZONE 2.2.2.2/32 enable > zone prefix HQZONE 011* > zone prefix IPIPGWCCMZONE 3... > gw-type-prefix 1#* default-technology > bandwidth interzone zone CCMZONE 144 > no shutdown > ! > ! > > > HQ config : > > interface FastEthernet0/0.11 > encapsulation dot1Q 11 > ip address 114.0.0.254 255.255.255.0 > no snmp trap link-status > h323-gateway voip interface > h323-gateway voip id HQZONE ipaddr 7.7.7.7 1719 > h323-gateway voip h323-id [EMAIL PROTECTED] > h323-gateway voip tech-prefix 3# > ! > gateway > > ########MC3810 config :#################### > > interface Ethernet0 > ip address 200.0.0.100 255.255.255.0 > h323-gateway voip interface > h323-gateway voip id FXSZONE ipaddr 7.7.7.7 1718 > h323-gateway voip h323-id MC3810 > h323-gateway voip bind srcaddr 200.0.0.100 > ! > gateway > > > regards, > > Jeremy > > > NOTICE: This electronic mail message and any files transmitted with it are > intended > exclusively for the individual or entity to which it is addressed. The > message, > together with any attachment, may contain confidential and/or privileged > information. > Any unauthorized review, use, printing, saving, copying, disclosure or > distribution > is strictly prohibited. If you have received this message in error, please > immediately advise the sender by reply email and delete all copies. > >
