We are discussing about Using transcoder in SB router for Fast Start Trans coder is not req in HQ for UCCX that is fine. But What about Fast Start??
On Sat, Jul 13, 2013 at 10:52 PM, Edgar Feliz <ejzi...@gmail.com> wrote: > In the CCX -> CM integration to g729 and reset CRS engine > > In CM Change the IP Voice Media Streaming App to G729 only. Then reset the > IP Voice Media Streaming App service. > > > On Sat, Jul 13, 2013 at 1:02 PM, IE Target <myfrnd...@gmail.com> wrote: > >> If we dont Use Transcoder >> >> HQ to SB (TEHO) calls will be unsuccessful (dropped due to unavailability >> of Xcoder) >> >> Thats why i think Xcoder is req >> >> Correct Me if i am wrong >> >> >> >> On Sat, Jul 13, 2013 at 6:08 PM, Edgar Feliz <ejzi...@gmail.com> wrote: >> >>> For F/S on site B you do not need the transcoder just MTP. Typical : max >>> session 100 would work. >>> >>> >>> >>> >>> On Sat, Jul 13, 2013 at 1:16 AM, IE Target <myfrnd...@gmail.com> wrote: >>> >>>> Ya >>>> MRGL_FS Contains MRG_FS which contains SB_Xcode and SB_MTP (G711) >>>> >>>> dspfarm profile 1 mtp >>>> associate application sccp >>>> codec g711ulaw >>>> maximum session software 4 >>>> no shut >>>> dspfarm profile 2 transcode >>>> associate application sccp >>>> codec g729r8 >>>> maximum session 2 >>>> no shut >>>> >>>> >>>> MRGL_FS is applied to only h323 GW. It works for me >>>> >>>> But My question is can we use only transcoder , i.e MRG_FS contains >>>> only XCode not MTP ? >>>> Other part is how many session to assign in dspfarm profile >>>> >>>> >>>> On Sat, Jul 13, 2013 at 1:57 AM, Karen Johnson < >>>> karen.johnson...@yahoo.ca> wrote: >>>> >>>>> hi friend, >>>>> >>>>> may i see your IOS config for this ? >>>>> >>>>> and also what in inside MRG-SB and MRGL-SB >>>>> >>>>> you only assign MRGL SB to GW h323, right ? >>>>> >>>>> K >>>>> >>>>> *From:* myfriend myfriend <myfrnd...@gmail.com> >>>>> *To:* Karen Johnson <karen.johnson...@yahoo.ca> >>>>> *Cc:* ccie_voice@onlinestudylist.com >>>>> *Sent:* Friday, July 12, 2013 12:45:35 AM >>>>> *Subject:* Fast Start >>>>> >>>>> These are my finding >>>>> >>>>> No need to enable fast start on Router , by default it will use Fast >>>>> Start >>>>> >>>>> Assgn MRGL to SB Gw which contain Only G711 MTP (and transcoder) >>>>> >>>>> Check MTP Required >>>>> Check Outbound FS >>>>> Check Inbound FS >>>>> >>>>> That it >>>>> Am i missing any thing >>>>> >>>>> >>>>> >>>> >>> >> >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
