Many thank Justin. This is very helpful. Best regards
Paul Onwude (Please excuse the brevity of this email as it was sent via a mobile device. Kindly excuse misspelled words or sentence structure) > On 4 Nov, 2013, at 7:28 pm, Justin Carney <justin.s.car...@gmail.com> wrote: > > If you're adding the plus I cucm this is expected behavior that it will be > lost at the ios gw. You're not missing anything on cucm, this is just how > h323 works on ios routers...the only option is to add a plus in the ios > gateway. > > IOS/h323 will (by design, unfortunately) discard a plus in dnis on the > inbound call leg, so make sure you are adding it on the outbound dial or > voice port. (You might be able to add plus on an inbound dial peer but I > haven't tried and not sure if it would then get discarded.) > > For the lab I would recommend doing ALL h323 digit manipilation on the h323 > gw. If you do it in cucm then later when you need to do srst you will need > extra dialpeers and/or translations. > > For example, I use only 4 outbound pots dialpeers in h323 each with a > translation profile that modifies ani (for each site, matching 2... 3... and > 4...) and dnis (usually just type/plan). I send all the dialed digits from a > phone to the h323 gw the let the gw make the ani and dnis match the pstn > requirements for all call types including teho. > > The only time I modify digits in cucm is when "no new rp is alowed for 911 at > site b" and that uses slrg - the ani is masked to 7digits in cucm, but the > h323 still must set ani/dnis type and plan to unknown for dnis. Also, for > teho from site a to site b pstn, I would strip the 91408 from the dialed > digits and prefix 9 in the route list/rg for h323 so it matches my outbound > local dialpeer. > > Hope this helps. > > -Justin > >> On Nov 4, 2013 2:19 AM, "Paul Onwude" <ponw...@gmail.com> wrote: >> Hi All. >> Need expert opinion on this. >> I have a H323 gateway and i have setup called party transformations on CUCM >> to send “+” to the gateway. My issue is i don’t see the plus when i debug >> ids q931. When i do other digit manipulation like adding “#”, it show up on >> the gateway but not the “+” >> >> I know i can probably achieve this using translation on the GW but i can’t >> help but think there is something i am missing in CUCM. >> >> Any ideas?? >> >> Paul >> >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com