Hmm, this happened to me a few years ago. If I recall correctly, you can't pass traffic to the standby PIX in an active/standby pair. What does "show failover" say on the active PIX - can it see it's standby neighbor, and do the interfaces look normal?
--afsheenb Ultramajestic wrote: > I have an active and a passive pix failover configuration, the situation > is that the passive node is not reachable, I can't do ping neither > telnet. > > I think I should go there with my laptop and serial cable since I am not > sure if the serial number is available as stick :-/ > > El jue, 07-02-2008 a las 10:34 -0800, Jay Hennigan escribió: >> Ziv Leyes wrote: >>> How far away are you from that device? Can't you just plug a console cable >>> to it and check? >> If he is close enough to plug in a console cable, he's probably close >> enough to read the serial number on the nameplate. >> >> -- >> Jay Hennigan - CCIE #7880 - Network Engineering - [EMAIL PROTECTED] >> Impulse Internet Service - http://www.impulse.net/ >> Your local telephone and internet company - 805 884-6323 - WB6RDV >> _______________________________________________ >> cisco-nsp mailing list cisco-nsp@puck.nether.net >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ > > _______________________________________________ > cisco-nsp mailing list cisco-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/