Hi Guys I have configured Multihomed OTV in a virtual lab on EVE-NG using Cisco CSR's. The lab is 2 x CSR at one site both connected to layer2 switch and a single CSR at a remote site. Everything works good apart from one thing. At the dual router site, when I drop the OTV WAN/Overlay interface on the active CSR R1, the remote mac appears in the R2 bridge-domain (as it should) but the 'customer' layer 2 switch mac address table still show the mac address as facing the R1 LAN. After 5 minutes the mac table times out and traffic is then restored over the R2 path. Is there any way R2 can update the customer L2 switch when the remote mac moves over to it to make the failover quicker? I did read a Cisco article that said if spanning tree is enabled on the OTV router, it will send out a TCN which will update the L2, I have spanning tree enabled on the OTV routers but when I drop the OTV WAN/Overlay interface, it does not send out a TCN, I had wireshark running.
Thanks Rick -- If you try to reinvent the wheel you will end up with something non-round and should expect an uncomfortable ride. The wheel has no copyright. Richard Clayton - 17/11/2014. _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/