Jeremy, This scenario works with the DVTB application present in the DVSDK 3.10 installation. We could sequentially encode two YUV 420SP streams of size 1920x1088 and 1280x720 using two codec instances. However we have kept the maxWidth to 1920 and maxHeight to 1088 for both instances.
Can you try closing the Codec Engine and open it once again before creating the second instance? You might get some clue. If possible you can try running the DVTB as well. Regards, Prem ________________________________ From: davinci-linux-open-source-boun...@linux.davincidsp.com [mailto:davinci-linux-open-source-boun...@linux.davincidsp.com] On Behalf Of Jeremy Larsen Sent: Wednesday, April 07, 2010 10:32 PM To: davinci-linux-open-source Subject: DM365 H.264 Encoder size change problem I am having a problem anytime I change the height and width setting of the H.264 encoder on the DM365. I have tried sending XDM_RESET control message to the encoder to try and reset it before I change to the new size. I have even deleted and recreated the encoder with VIDENC1_delete and VIDENC1_create calls before starting the new size and the produced bitstream is still not correct. The syntax is correct but the decoded image is not. I can independently encode either size setting (after a board reboot) correctly, but when I try to switch size the problem occurs. I am using dvsdk_3_10_00_03. Can anyone offer any advice? Jeremy ________________________________ The New Busy is not the too busy. Combine all your e-mail accounts with Hotmail. Get busy.<http://www.windowslive.com/campaign/thenewbusy?tile=multiaccount&ocid=PID28326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_4>
_______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source