Roneil,
The way to maintain the address on the server depends on how DNS is configured. IF this webserver needs to be accessible from both the inside and outside, then the best solution is to edit the pages. That is unless the pages were coded with a registered External address, in this case it would make sense to use registered addresses in the DMZ to aleviate the need to recode the pages. If you intend to use RFC 1918 addresses in the DMZ then you will need to recode the pages so they function properly from both the translated external address and the users of the internal LAN accessing the RFC 1918 addresses. HTH
Ken Claussen MCSE CCA CCNA
[EMAIL PROTECTED]
"The mind is a terrible thing to waste!"
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Ronneil Camara
Sent: Wednesday, August 16, 2000 12:43 PM
To: [EMAIL PROTECTED]
Subject: RE: IP addressing on firewall
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]
> Sent: Wednesday, August 16, 2000 10:42 PM
> To: Ronneil Camara; [EMAIL PROTECTED]
> Subject: RE: IP addressing on firewall
>
>
>
> Ronneil,
>
> #Supposed we have the following config:
> #e0 = 172.16.1.1
> #e1 = 172.16.1.5
> #e2 = 222.2.2.2
> #router lan = 222.2.2.1
>
> I like to assign different subnets to all of my network
> cards. You may
> want to change e1 to 172.16.2.1. Unless my math sucks (which
> it does) both
> e0 and e1 are in the same subnet.
That's ok since I'm using /24 both on e0 and e1.
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
