On Thu, May 10, 2018 at 09:21:10AM +0000, Grzegorz Junka wrote: > > On 08/05/2018 23:41, Justin Clift wrote: > > On 2018-05-08 21:59, Grzegorz Junka wrote: > >> Hi All, > >> > >> pciconf -lv > >> > >> gives me > >> > >> none1@pci0:3:0:0:???????????? class=0x0c0600 card=0x000315b3 > >> chip=0x634015b3 > >> rev=0xa0 hdr=0x00 > >> ?????? vendor???????? = 'Mellanox Technologies' > >> ?????? device???????? = 'MT25408 [ConnectX VPI - IB SDR / 10GigE]' > >> ?????? class?????????? = serial bus > >> > >> Does it mean that my card is unrecognized? It supposed to be 10GB x 2 > >> Infiniband PCI-E HCA 500EX-D Dual-Port Card Mellanox Firmware. > >> Currently the card doesn't show when doing ifconfig. What should I do > >> to have the proper device name instead of none1 or for the card to > >> appear in ifconfig? > >> > >> # kldstat > >> Id Refs Address?????????????????????? Size???????? Name > >> ??1???? 28 0xffffffff80200000 1f67a88?? kernel > >> ??2?????? 1 0xffffffff82169000 316708???? zfs.ko > >> ??3?????? 2 0xffffffff82480000 cb78???????? opensolaris.ko > >> ??4?????? 1 0xffffffff8248d000 42c28?????? mps.ko > >> ??5?????? 1 0xffffffff82621000 bdb0???????? if_lagg.ko > >> ??6?????? 1 0xffffffff8262d000 3650???????? ums.ko > >> ??7?????? 1 0xffffffff82631000 6679???????? nullfs.ko > >> ??8?????? 1 0xffffffff82638000 bdfe???????? unionfs.ko > >> ??9?????? 2 0xffffffff82644000 2094f?????? mlx5.ko > >> 10?????? 2 0xffffffff82665000 103e1?????? linuxkpi.ko > >> 11?????? 1 0xffffffff82676000 15965?????? mlx5en.ko > > > > That's probably a ConnectX (series 1) Mellanox card.?? Those can > > operate in > > either Infiniband mode, or Ethernet mode. > > > > Which mode are you wanting it to run in? :) > > > > As a thought, the FreeBSD wiki page has a bit of info: > > > > ?? https://wiki.freebsd.org/InfiniBand > > > > For that card to be recognised at all, it'll need the mlx4 driver(s) > > to load. > > > > I don't remember the exact one off hand (it's been a while), but some > > searching > > online for mlx4 and FreeBSD should turn up the right bits. > > Many thanks Justin. This is the first time I am hearing about an > Infiniband card operating in Ethernet mode. These cards come with two > CX4/SFF 8470 ports. It's not possible to connect standard Ethernet > cables that I know of (not even SFP modules). Do you mean that they can > operate in Ethernet mode over the CX4 cable?
You can get CX4 to SFP+ cables, so I would assume so Regards Gary _______________________________________________ freebsd-net@freebsd.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"