Thanks for the help! -Joel
> -----Original Message----- > From: [EMAIL PROTECTED] [mailto:geda-user- > [EMAIL PROTECTED] On Behalf Of John Luciani > Sent: Wednesday, December 27, 2006 3:31 PM > To: gEDA user mailing list > Subject: Re: gEDA-user: PCB footprint - 2 sided part > > On 12/27/06, Ostheller, Joel A. <[EMAIL PROTECTED]> wrote: > > > > > > Can I get some tips on how I would create a footprint for this SMA right > > angle connector that lives on both sides of the board? Should I create > it > > with through holes? Should I create two footprints and just make sure to > > line them up? > > A footprint can have pads on both sides of the PCB. You can also overlay > pads and a pin to get the loollipop(?) at the end of the outer pads. > The footprint below shows top and bottom pads and should match the > first part in the spec table. > > (* jcl *) > -- > http://www.luciani.org > > Element[0x0 "Coax" "" "" 0 0 0 0 0 100 0x0] > ( > Pad[0 -5500 0 5500 9000 2000 11000 "" "1" 0x0100] > Pad[0 -5500 0 5500 9000 2000 11000 "" "1" 0x0180] > Pad[-17000 -5250 -17000 5250 9500 2000 11500 "" "2" 0x0100] > Pad[-17000 -5250 -17000 5250 9500 2000 11500 "" "2" 0x0180] > Pad[17000 -5250 17000 5250 9500 2000 11500 "" "2" 0x0100] > Pad[17000 -5250 17000 5250 9500 2000 11500 "" "2" 0x0180] > ) > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user