On Jan 29, 2007, at 7:51 PM, Mark Rages wrote:
Unfortunately space is at a premium in laser tag guns, so
hopefully I can
make it work. I'm not sure I'd even want to attempt an SMT board
at home.
Reflowing sounds a bit tricky.
Hand-soldering SMT isn't bad, unless its the real teensy-tiny SMT.
I'd say it's easier than flipping the board over while soldering
through-hole. It is harder to layout one-sided however: You can run
half a dozen traces under a through-hole resistor, but only one under
a SMT resistor.
I agree 100% here...I actually find through-hole soldering to be
more difficult and tedious than SMT now. All but the very tiniest
SMT parts can be soldered with a quality iron.
-Dave
--
Dave McGuire
Port Charlotte, FL
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user