The "PolyArea" is value specifies the minimum area a poly region must have to survive a "MorphPolygon()" operation.
Use the ":MorphPolygon(Object)" command to "restore" the dead copper areas larger than PolyArea to the board. This command converts the disjoint copper areas into separate polygons. The "object" that the cursor must be over is the remaining (i.e. non-removed) portion of the polygon. I don't remember if I implemented the "selected" argument for the command, but if I didn't I'm sure you know how to. h. --- DJ Delorie <[EMAIL PROTECTED]> wrote: > Can this be disabled on a per-board or per-poly > basis? I'm trying to > use it to preserve etchant, but it's difficult to > get enough coverage > without getting too close to the traces and such. > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > ____________________________________________________________________________________ Looking for earth-friendly autos? Browse Top Cars by "Green Rating" at Yahoo! Autos' Green Center. http://autos.yahoo.com/green_center/ _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user