DJ, I'm beginning to feel a little dense. I re-ran configure as you indicated below, but as far as I can tell, lesstif is not running. I even went so far as to create a /home/lesstif_user directory, and did the lesstif "configure-make-make install" operations in that directory, then modified the local .bash_profile file to point to the pcb code. Again, same thing. I could execute pcb, with the 32 layers, but it looked to me like I was still running gtk, not lesstif.
Any further suggestions? Harold Skank On Mon, 2007-04-09 at 16:11 -0400, DJ Delorie wrote: > > Could you encapsulate the configuration necessary to run lesstif just on > > the /home/designer user who uses pcb? > > ./configure --with-gui=lesstif > > > I want to thank for your assistance so far. Unfortunately, I'm not done > > yet. Also, what should I look for that would tell me that lesstif is > > running as opposed to gtk? > > gtk has the sidebar on the left, lesstif doesn't. > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user