Hi, In PCB, looking under File->Preferences, then Layers, Groups shows four default groups.
Group 1 is solder, Vcc-solder, GND-solder Group 2 is component, Vcc-comp, GND-comp Group 3 is "solder side" Group 4 is "component side" Question 1: Each "Group" will be a physical layer of copper, correct? I want to make a 4-layer board with the middle two layers being ground and power, so to my way of thinking the following is a reasonable layer and group assignment (I'm not using any surface mount devices on this particular board): Group 1: component, component side Group 2: GND Group 3: Vcc Group 4: solder, solder side Question 2: In this a reasonable assignment, or am I missing something? Question 3: I'm assuming the best way to make the power and ground layers are to simply flood-fill them with copper, and then the components will attach by the pin connections. Is it really just that easy? Thanks! --Jim _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user