Hello guys,
I've finished a board I've been working on, though I have a question about
both, it's proper setup and output.
Since I'm doing a one side board, I've just left the solder layer (where my
routes live), and the ground layer, which is where I have the ground plane,
both of them on the same group (layout's solder side).
Then, I haven't got nothing on the component side (not even a compoment layer
as such), still I can see the layout as I guess I should by using the tab key
(the solder and ground plane in one, and just the components' silkscreen on the
other).
And so at output time I'd expect to see a mirrored solder layer (one side), and
the mirrored component layer (just the silkscreen) but I never get to see the
mirrored silkscreen on my ps output so tonner transfer would leave things as
I'd like to.
While I can achieve this by tweaking ps output options, I'd appreciate if
someone could tell me what I'm doing wrong, or missunderstanding in here.
I used to have the compoment layer, but since it was empty I just deleted it.
Now in the layers' group window I have solder and ground on group one (solder
side), and nothing on group two (component side).
Many thanks.
Eduardo,
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
