Hi guys,
I've noticed I could set on gschem's the `value' attribute for each symbol
which could be then shown on the final layout, which I find so nice and I
prefer over the default scheme.
Is there anyway I can control it's text's size once on pcb? I have tried
changing the `text scale' option's value from within the preferences menu and
restarting pcb, but it only seems to apply for newly/manualy created text.
Also, I've noticed that `gsch2pb' truncates white spaces on symbols' value
attributes to underscores, though nothing wrong seems to happen if I emacs the
resulting pcb and remove them. Is there anyway to let gsch2pcb not to do this?
Ah, and another thing yet!. I got to a point where I had to delete the ground
plane layer and rebuild it/regroup it because after some retouches, the ground
plane got completely twisted. By times not even turning off `thin draw poly' I
could see it at all.
I've just noticed that not letting routes lay too near from components
(especially when it will stay in parallel with such components' pins) will
somehow cause the logic to confuse less.
For example, it seems that for this time, a route from top to bottom in the
middle of a vertically placed dip28 package, was causing this behaviour cose of
beeing drawn too near to the pins (the package was placed vertically also). I
found this out on a completely trial and error scheme, but after I did redraw
it a bit more separated I haven't had to rebuild the ground plane anymore, even
when I've made several changes to the layout afterwards.
And sorry for the very long post, but that leads me to another question in
regards to the previous answer from Delorie to me.
I've finally kept the component layer on my layout as advised. I've temporally
placed there guides used to rebuild the ground plane when needed.
Now, I'm just curious cose Delorie said that I can disable the layer so (I
understood) it won't be rendered at output time time even if it got things
drawn on it.
However, I don't seem to be able to achieve it. The only way I could think of
disabling a layer is pressing on it's name up in the upper left hand side stack
behind the menu bar, but then it get's written to the output file (postscript
is what I'm using).
Is there anyway to avoid this?
Thanks,
Eduardo.
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
