On Mon, 2008-12-01 at 00:30 +0000, Kai-Martin Knaak wrote: > On Sun, 30 Nov 2008 21:20:27 +0000, Peter Clifton wrote: > > > Hmm, I thought I'd fixed that. Have you updated from git recently? > > <looks at date of binary> > It was compiled in June. So it has been some time since I did the last > update. > > I have never compiled pcb from git. Always took this CVS repository: > :pserver:[EMAIL PROTECTED]:/cvsroot/pcb
If you're running PCB+GL, you must have grabbed it from git at some point. If you had your original checkout, you might just run a "git fetch" in that directory then: git checkout -b before_pours_local origin/before_pours Alternatively, if the git checkout is lost, start from scratch.. git clone git://repo.or.cz/geda-pcb/pcjc2.git git checkout -b before_pours_local origin/before_pours then run ./autogen.sh, ./configure, etc... > Just tried to update the pcb source from this CVS repository. Some > changes could be applied. So I moved everything except the CVS dir out of > the way and started from scratch. However, autogen seems to run into > problems at the aclocal stage. Consequently, automake fails too. I get > these messages on stderr: aclocal is just complaining I think. What appears to be missing is part of your PCB checkout. Try "cvs up" again. > > You want the "before_pours" branch of my repository. "master" now > > contains other stuff, such as experimental poured copper areas, which > > will currently break the way existing layouts load. > > Can you give the address of the git repo? See the above git examples for how to check it out. You can browse the thing on-line at: http://repo.or.cz/w/geda-pcb/pcjc2.git -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user