On Tue, 2009-03-31 at 23:43 -0400, DJ Delorie wrote: > Hey, they have a 4.5" diamond blade that will fit in my table saw, > too. They don't say how wide it is, though.
I've had poor luck trying to saw boards apart with my Dremel. Maybe my hands just aren't steady enough? Particularly trying to hold edge location tolerances tightly enough to repeatably place solder past with the simple frame fixture I made up. A diamond wheel is way better than a normal abrasive wheel, but still not easy for me to use successfully. I'm happily using my little table-top 3-axis CNC mill to cut my TeleMetrum panels apart with a very small diameter end mill and a hold-down fixture I made up... basically a block of wood surfaced and with holes drilled and tapped to allow me to screw the individual boards in a panel down so that they stay in place as I'm cutting them apart. Tedious, but I'm able to hold all the dimensions I care about to within a mil. If I had a suitable shear I'd use it... Bdale _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user