Hello Fellows, I've added a chassis ground and used the symbol: chassis.sym but when I compile the schematic to using gnetlist: I get the following: "Missing Attributes (refdes and pin number) Missing Attributes (refdes and pin number) Missing Attributes (refdes and pin number) Missing Attributes (refdes and pin number) Missing Attributes (refdes and pin number) ... (snip)" when I check the output file, it reads: (snip) Found pins without the 'pintype' attribute: H4:1 H3:1 H2:1 H1:1 U?:? (snip) The H1-H4 are four mounting holes, but why only one "U?:?" and when I check my .net file I noticed this: harpy01C.net:unnamed_net40 U?-? J4-G harpy01C.net:unnamed_net29 U?-? J3-G harpy01C.net:unnamed_net26 U?-? J6-G harpy01C.net:unnamed_net25 U?-? J5-G harpy01C.net:unnamed_net24 U?-? J8-G harpy01C.net:unnamed_net23 U?-? J7-G harpy01C.net:unnamed_net14 U?-? J2-G harpy01C.net:unnamed_net3 U?-? J1-G These correspond to the Ground connect pins on my connector that are now connected to Chassis GND. I labeled the net "CGND" Have any of you come across this issue with chassis.sym? Any ideas that you folks might have to solve this will be greatly appreciated. Thank you. // Sal Aguinaga // Northwestern University
__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com
_______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user