Kai-Martin Knaak wrote: add the flag "onsolder" to the pad you want to put on the other side. See page 24 of [1]http://www.brorson.com/gEDA/land_patterns_20070818.pdf
If you prefer to do footprints in the GUI of pcb, lines that are in the "solder side" layer group, get the onsolder flag. ---<(kaimartin)>--- Vanessa Ezekowitz wrote: There are a couple of Commodore 64 edge connector footprints in my [2]gedasymbols.org repository that demonstrate this also, in case that is useful to you: [3]http://www.gedasymbols.org/user/vanessa_ezekowitz/ Thank you, gentlemen. As always, this is the most helpful group. Jim References 1. http://www.brorson.com/gEDA/land_patterns_20070818.pdf 2. http://gedasymbols.org/ 3. http://www.gedasymbols.org/user/vanessa_ezekowitz/
_______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user