Here's a weird problem. I am using two inductors with the same footprint in a small two layer design. After laying out the board I exported a ps version of the board. I then used ps2pdf to convert the layout for my printer. When I open the pdf document in windows the layout looks exactly the way it should (all the foootprints are correct). When I print out the etch patterns to make the board both pads for both inductor are missing even though they are there in the pdf! Has anyone ever had this happen? Here is the foot print: Element ["" "" "" "" 10 10 -25000 -20000 0 100 ""] ( Pad [-20650 0 -20642 0 11000 1200 1500 "" "1" "square"] Pad [20642 0 20650 0 11000 1200 1500 "" "2" "square"] ElementArc [0 0 25000 19650 250 40 100] ElementArc [0 0 25000 19650 70 40 100] ElementArc [0 0 10000 10000 0 360 100] #cirle ElementLine [-15000 -4900 -15000 4900 100] #inside verticle lines of pads ElementLine [15000 -4900 15000 4900 100] ElementLine [-24400 -4900 -15000 -4900 100] #bottom horizontal line of pad ElementLine [-24400 4900 -15000 4900 100] ElementLine [24400 -4900 15000 -4900 100] #top horizontal line of pad ElementLine [24400 4900 15000 4900 100] ElementLine [-24400 -9800 -24400 9800 100] #outside verticle lines of pads ElementLine [24400 -9800 24400 9800 100] ElementLine [-8500 -18000 -24400 -9800 100] ElementLine [8500 -18000 24400 -9800 100] ElementLine [-8500 18000 -24400 9800 100] ElementLine [8500 18000 24400 9800 100] )
_______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user