Hi everyone,
I need some advice.
I have been doing tissue processing (on an old Shandon Hypercenter),
embedding and sectioning for 15 yrs. and never really had any problems.
I recently processed mouse tissues on a brand new tissue processor
(Leica ASP300S). When I went to cut 5 micron sections the tissues
(spleen, heart, aorta and lung) were very dry and brittle. They made
what looked like sawdust after each cut. Soaking them in cold ammonia
water helped some; but they still did not cut nicely.
Here is my protocol:
I perfusion fixed the mouse with fresh 10% Neutral Buffered Formalin
(NBF). Then I removed the tissues and cut them in smaller pieces (no
more that 5mm thick) and put them in 10% NBF for 24 hrs., then washed
with PBS and stored in 70% ethanol (made with PBS) for 2 days before
processing (only because I didn't have time to process till then).
My processing protocol is as follows:
70% ETOH x1 1hr.
95% ETOH x2 1hr each
100% ETOH x3 1hr each
Xylene x3 1hr each
wax x3 45 min each 60°C
Can any one tell me why they think my tissues are so so dry. What could
I change for the next time I do this?
Thank you.
Sheri Kelemen
Research Associate
Cardiovascular Research Center, Temple University
3500 N. Broad St.
Philadelphia, PA 19140
215-707-3170 work
skele...@temple.edu
_______________________________________________
Histonet mailing list
Histonet@lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet
