We are attempting to move from SNA network to APPN. We have two guest ZOS systems which I have executed a DEFINE CTCA 200 and DEFINE CTCA 201 on both systems. I issued the COUPLE 200 TO ZOSB 200 and COUPLE 201 TO ZOSB 201 from ZOSA. The addresses are defined in the HCD for both ZOS systems. We currently do a similar connection for the SNA connection. When vary the TRL active on ZOS and then display the LINE it is showing the Channel in RESET status and the line does not come active.
Did I miss something in the VM virtual device definitions? Is there a way of clearing the RESET status. Here is the display of the LINE from ZOS. D NET,ID=TRLEZOSA IST097I DISPLAY ACCEPTED IST075I NAME = TRLEZOSA, TYPE = TRLE IST486I STATUS= NEVAC, DESIRED STATE= INACT IST087I TYPE = LEASED , CONTROL = MPC , HPDT = *NA* IST1954I TRL MAJOR NODE = TRLZOSA IST1715I MPCLEVEL = HPDT MPCUSAGE = SHARE IST1221I WRITE DEV = 0200 STATUS = RESET STATE = N/A IST1221I READ DEV = 0201 STATUS = RESET STATE = N/A IST1500I STATE TRACE = OFF IST314I END William Boyer Principal Administrator, Mainframe Systems ViPS, a General Dynamics Information Technology Company Business & Technology Services One West Pennsylvania Avenue Baltimore, MD 21204 Tel. 410.832.8300 Fax. 410.832.8329 bil...@vips.com <mailto:bil...@vips.com> www.vips.com <http://www.vips.com/> This message is confidential, intended only for the named recipient (s) and may contain information that is privileged or exempt from disclosure under applicable law. If you are not the intended recipient (s), you are notified that the dissemination, distribution or copying of this message is strictly prohibited. If you receive this message in error or are not the named recipient (s), please notify the sender at either the fax address or telephone number above and delete this message. Thank you.