Hi Ras, Unfortunately the Px-4FE-TX is 100M only - see http://www.juniper.net/techpubs/software/junos/junos84/swconfig84-networ k-interfaces/id-12154979.html
"Note: The statement speed (10m | 100m) applies only to the management Ethernet interface (fxp0) and to the Fast Ethernet 12-port and 48-port Physical Interface Cards (PICs). The 4-port and 8-port Fast Ethernet PICs support a speed of 100 Mbps only." Would be nice to get a tri-state 10/100/1000 card for the M-Series like the new ones in the J-Series! Regards, Phil -- Phil Sykes Technical Consultant JNCIE-M #227 Imtech Telecom Mobile: +44 (0) 7823 530 630 http://www.imtechtelecom.co.uk/ > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Ras > Sent: 05 September 2007 10:47 > To: juniper-nsp@puck.nether.net > Subject: [j-nsp] Setting PE-4FE-TX port to 10m gives 'Illegal > media change:invalid speed' > > > I've just tried to set a port on an PE-4FE-TX to 10m (set > interfaces fe-0/0/1 speed 10m). This works fine on our > PE-12FE-TX and the 'commit check' says all is well, but when > I commit I get: > > /kernel: %KERN-2: fe-0/0/1: Illegal media change: invalid speed > > Are these 100m only ports? If not, what else might be wrong? > > Thanks, > Ras > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/junip> er-nsp > > > > ______________________________________________________________________ > This email has been scanned by the MessageLabs Email Security > System. For more information please visit > http://www.messagelabs.com/email > > ______________________________________________________________________ > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp