There is a card, but it is located underneath the daughter board that hold the hard drive. I do not believe there is an officially supported method for upgrading the CF on RE2. However in our lab we have had success replacing them with standard Sandisk 1gb CF cards. That involves removing a number of screws from the bottom and removing the face plate. Then you must remove the daughterboard containing the HD and there is another daughterboard underneath that holds the CF card.
On 12/25/07, Mykola Mitrokhin <[EMAIL PROTECTED]> wrote: > hello David, > > Thank you for your quick reply. I have read the requirement. But i use a > RE-2.0 333 768 routing engine in this system, > 'without' a flash card. There is no card onboard or in the back. Is there no > option to resize partitions or something? > > Thank you for your great help. > > best regards, > mykola > > > 2007/12/25, David Ball <[EMAIL PROTECTED]>: > > > > Hi Mykola. Check out the release notes for JunOS 8.5. > > > > http://www.juniper.net/techpubs/software/junos/junos85/rn-sw-85/release-8.5-features.html#rn-new-features > > > > In the section that discusses FreeBSD they make mention to the > > requirement of a 256MB or larger Compact Flash card (part of your RE) > > in order to install 8.5. Sounds as though yours doesn't meet this > > criteria. The cheap way to get around this is to stick with older > > code, the more expensive way is to upgrade your compact flash. There > > have been some discussions about this in the last week or 2 on the > > list, so perhaps peruse the archives as well for others' experiences. > > > > David > > > > > > On 25/12/2007, Mykola Mitrokhin <[EMAIL PROTECTED]> wrote: > > > Hello, > > > > > > I have a problem with upgrading one of our juniper routers, currently it > > is > > > running JunOS 8.3. > > > I wanted to upgrade to -8.5R1.14 > > > > > > I started the upgrade and it ends with the following error: > > > > > > ********************* > > > > > > Adding jinstall... > > > > > > WARNING: This installation will not succeed. > > > WARNING: The boot device is less than 256M. > > > WARNING: A hardware upgrade is required. > > > > > > ERROR: jinstall fails requirements check > > > > > > ********************** > > > > > > How can i fix this? I use RE-2.0 333-768 > > > > > > > > > > > > Thanks for your help in advance. > > > > > > > > > > > > Best wishes, > > > > > > mykola > > > _______________________________________________ > > > juniper-nsp mailing list juniper-nsp@puck.nether.net > > > https://puck.nether.net/mailman/listinfo/juniper-nsp > > > > > > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > -- Shawn Morris IP Development - NTT America [EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED] v: +1 214 915 1361 f: +1 815 327 3016 _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp
