Hi Marlon The output of "show system storage" should give some idea regarding the memory space available.
also try running the validate command and check the error you observe request system software validate <pathname> Thanks Vineet On 7/23/08, Marlon Duksa <[EMAIL PROTECTED]> wrote: > Hi - I'm trying to upgrade an older M20 from Jun8.4 to 9.1 and this is the > message I get. > What boot device is in question here? I'm doing the upgrade from the hard > disk and not the install media. Is there any way to see this boot device by > show cmd? > > Installing package '/var/tmp/jinstall-9.1R2.10-domestic-signed.tgz' ... > Verified jinstall-9.1R2.10-domestic.tgz signed by PackageProduction_9_1_0 > Adding jinstall... > > WARNING: This installation will not succeed. > WARNING: The boot device is less than 256M. > WARNING: A hardware upgrade is required. > > ERROR: jinstall fails requirements check > ERROR: jinstall-9.1R2.10-domestic-signed fails post-install > > [edit] > [EMAIL PROTECTED] run request system reboot > > Thanks, > Marlin > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > -- ---Vineet _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp