Do you see this page? http://www.juniper.net/techpubs/software/junos/junos91/rn-sw-91/frameset.html
Note: With JUNOS Release 9.0 and later, the compact flash disk memory requirement for JUNOS software is 1 GB. For M7i and M10i routing platforms with only 256 MB memory, see the Customer Support Center JTAC Technical Bulletin PSN-2007-10-001 at https://www.juniper.net/alerts/viewalert.jsp?txtAlertNumber=PSN-2007-10-001&actionBtn=Search. -- Yasuyuki Hamada On Wed, 23 Jul 2008 10:59:45 -0700 "Marlon Duksa" <[EMAIL PROTECTED]> wrote: > Hi - I'm trying to upgrade an older M20 from Jun8.4 to 9.1 and this is the > message I get. > What boot device is in question here? I'm doing the upgrade from the hard > disk and not the install media. Is there any way to see this boot device by > show cmd? > > Installing package '/var/tmp/jinstall-9.1R2.10-domestic-signed.tgz' ... > Verified jinstall-9.1R2.10-domestic.tgz signed by PackageProduction_9_1_0 > Adding jinstall... > > WARNING: This installation will not succeed. > WARNING: The boot device is less than 256M. > WARNING: A hardware upgrade is required. > > ERROR: jinstall fails requirements check > ERROR: jinstall-9.1R2.10-domestic-signed fails post-install > > [edit] > [EMAIL PROTECTED] run request system reboot > > Thanks, > Marlin > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp