Please disable cdp and keepalives on Cisco port connected to this M7i.
Also, disable spanning tree on this port by configuring it as an access
port.
Thanks,
Nilesh.
Samit wrote:
Hi, I just installed my first juniper M7i in the production couple of
hour back and after resolving few routing issue so far it is running
smoothly. I noticed that my PE-1GE-SX-B interface is showing only
"Policed discards", the counter which increases by 1 in every 1-2 secs
but the inbuilt GE is showing no errors. As I am not running any
qos/policing in the interface I was wondering what does it means..and
how to fix this error? the router's both interface is connected with a
Cisco 3400ME in different Vlan.
interfaces {
ge-0/0/0 {
description " Cisco3400-ME Gi0/1 Vlan2";
unit 0 {
family inet {
address 192.168.0.1/28;
}
}
}
Delay: 1/0/1
Interface: ge-0/0/0, Enabled, Link is Up
Encapsulation: Ethernet, Speed: 1000mbps
Traffic statistics: Current delta
Input bytes: 3589144576 (34951312 bps) [26149611]
Output bytes: 4117970233 (36219936 bps) [27659648]
Input packets: 12654493 (15073 pps) [90668]
Output packets: 13058310 (15834 pps) [94510]
Error statistics:
Input errors: 0 [0]
Input drops: 0 [0]
Input framing errors: 0 [0]
Policed discards: 558 [4]
L3 incompletes: 0 [0]
L2 channel errors: 0 [0]
L2 mismatch timeouts: 0 [0]
Carrier transitions: 0 Output errors: [0]
Regards,
Samit
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp