Hello all, I would like to do Port Mirroring on an interface. I can mirror the IN traffic of my interface, but I can not mirror the OUT traffic.
The global topology is as follows: *J4300 *------------------ (mirrored port,1/3/0.100) *M7i*(1/3/1.0)----------------> Mirrored Traffic's destination. Here is the mirrored port: l...@m7# show interfaces fe-1/3/0 vlan-tagging; unit 100 { vlan-id 100; family inet { filter { input mirror_in; output mirror_out; } address 1.1.1.2/30; } } And the filters are as follows: l...@m7# show firewall family inet filter mirror_in term 1 { then { port-mirror; accept; } } The mirror_out filter is exactly the same as mirror_in. My Forwarding options are as follows: l...@m7# show forwarding-options port-mirroring { family inet { input { rate 1; run-length 1; } output { interface fe-1/3/1.0 { next-hop 10.10.10.2; } } } } When I generate a traffic between the J4300 and the M7i (a ping from J4300 to M7i for example), the M7i only mirrors the INPUT packets to the interface fe-1/3/1.0. I am sure that it's the input traffic (and not the output traffic) by deactivating the filters one by one. The output traffic is not mirrored at any time. Should I add/change some config to also mirror the output traffic, or is it a default Junos behaviour? (Junos: 8.3R2.11) Thanks in advance, Mario DEL RE _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp