Hi,
Wow that is old; I remember when 2.X came out for JUNOSe (UNISON as
the time). There may be an issue in the upgrade process for such an
old card. You can always console the line card directly (with a
straight through ribbon cable or even a regular ethernet cable on the
diag port if you remove a faceplate next to the line card) ...
Then when the card is booting up it should show where it is failing.
Likely it is during the POST or diag steps.
Check out juniper KB 1760 which might be the issue. I remember this
issue well, when upgrading to 3.2.X ....
If this is not the issue, you still will find more information that
will lead you down the right path if you console the card. Also, it
will certainly be good if you can upgrade the memory to at least 128MB.
Kind regards,
Truman
On 23/07/2009, at 11:35 PM, Dr Rocco DiSanto wrote:
Hi All,
I hope some knowledgeable individual can give me some guidance on an
ERX
1410 question....
I have a DPFE Line card & I/O which boots correctly under version
2.61(yea
I'm not kidding it's really that old) however when I attempt to move
the
line card & I/O to a chassis with OS ver 5.1.3 it does not come up.
A "Show version" command indicates the card is booting but it never
completes (and never fails). The mem on the line card under 2.6.1
showes to
be 64 Meg.
I know the Dual Port Fast Ether line card is EOL with version 7.x
but I only
need to get it to 5.1.3 right now.
Can anyone tell me what my issue might be?
Does the card require 128 Meg of mem to boot under 5.1.3?
Any guidance would be most appreciated.
Thanks for your consideration,
Rocco
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
