Thanx all for your input, I found out that OVPI can do the calc for me in HPOV. Also, the other methods discussed were also of great interest.
thanx, Mike On Fri, Aug 14, 2009 at 4:07 PM, Alex <alex.arsen...@gmail.com> wrote: > Apart from using Cacti/HPOV capabilities to calculate % usage, etc you > could do this by writing an event-script that takes interface stats, does > some trivial math and populates Utility MIB (jnxUtil). > Rgds > Alex > > ----- Original Message ----- From: "harbor235" <harbor...@gmail.com> > To: <juniper-nsp@puck.nether.net> > Sent: Thursday, August 13, 2009 2:06 PM > Subject: [j-nsp] monitor interface rate > > > To all, >> >> I would like to monitor a juniper router interface via snmp, simple >> enough. >> However, I do not want bps, I want to monitor the interface as a >> percentage >> of it's total capacity. In the end I want to be notified if my interface >> exceeds 70% >> of capacity so I can initiate capacity management planning. >> >> I know I can on an interface by interface basis figure out 70% and program >> that into >> each interface collection, however, that does not scale. Is there anyone >> out >> there >> that knows of a MIB obect that does this? >> >> thanx, >> >> Mike >> _______________________________________________ >> juniper-nsp mailing list juniper-nsp@puck.nether.net >> https://puck.nether.net/mailman/listinfo/juniper-nsp >> >> > _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp