Hello everyone, I just got my hands on a Juniper mx router and I'm starting the initial config in preparation to convert from Cisco. As I configure the interfaces, I can't seem to figure our how to create a routed vlan interface and have the ability to trunk it down multiple physical interfaces. I've looked up on the the web but was unable to find anything that direct describes what I'm trying to achieve.
Below is a sample config from a Cisco; ! spanning-tree mode pvst spanning-tree vlan 200 priority 8192 ! interface GigabitEthernet2/1 switchport switchport trunk encapsulation dot1q switchport trunk allowed vlan 200 switchport mode trunk switchport nonegotiate ! interface GigabitEthernet2/10 switchport switchport trunk encapsulation dot1q switchport trunk allowed vlan 200 switchport mode trunk switchport nonegotiate ! interface Vlan200 ip address 10.10.10.2 255.255.255.192 no ip redirects no ip unreachables no ip proxy-arp standby ip 10.10.10.1 ! Can this be done on a MX router? if so, can a sample config be provided? Any help would be much appreciated. Michael _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp