Hi List, I have a situation where I need to take 3 PVC's that I am getting from a provider and land one of them on an ATM interface (OC-3) and possibly cross-connect the others to the second port in the PIC to send to another router (basically performing an ATM switch functionality). Can this be done on a "2x OC-3 ATM, SMIR" PIC on a m10i ?? And if so, can someone point me to some config samples as to how to do this?? I imagine this would be a CCC on interface, but I am a complete noob when it comes to ATM on the juniper. Relevent configs of what I need to do are below.
Current Cisco config... interface ATM2/0 no ip address ip route-cache flow load-interval 30 no atm ilmi-keepalive ! interface ATM2/0.1 point-to-point --------------------------> PVC I wish to terminate on the first OC-3 Port description ***Internet PVC*** ip address x.x.x.x 255.255.255.252 pvc 3/101 protocol ip x.x.x.x broadcast ubr 75000 encapsulation aal5snap ! ! interface ATM2/0.2 point-to-point ----------------------------> 1st PVC CCC to the second port to connect back to the cisco description Customer1 T1 #1 ip address x.x.x.x 255.255.255.252 pvc 3/102 protocol ip x.x.x.x broadcast ubr 75000 encapsulation aal5snap ! ! interface ATM2/0.3 point-to-point ----------------------------> 2nd PVC CCC to the second port to connect back to the cisco description Customer2 T1 #2 ip address x.x.x.x 255.255.255.252 pvc 3/103 protocol ip x.x.x.x broadcast ubr 10000 encapsulation aal5snap Thx, Clue _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp