Hi Experts, I have couple of queries on IS-IS
1) Just wondering what reference-bandwidth value in "show isis overview" indicates?? We have set reference-bandwidth as 1000g for ISIS. (We dont see this output with routers not having reference-bandwidth command) l...@mumbdst1> show isis overview Instance: master Router ID: x.x.x.x Adjacency holddown: enabled Maximum Areas: 3 LSP life time: 65535 Reference bandwidth: 3567587328 <<<--- Attached bit evaluation: enabled SPF delay: 200 msec, SPF holddown: 5000 msec, SPF rapid runs: 3 IPv4 is enabled, IPv6 is enabled Traffic engineering: enabled Restart: Enabled Restart duration: 200 sec Helper mode: Enabled Level 1 Internal route preference: 15 External route preference: 160 Wide metrics are enabled, Narrow metrics are enabled Level 2 Internal route preference: 18 External route preference: 165 Wide metrics are enabled 2) We have few routers in the setup & all in Level-2. (Level1 disabled). In that case, shouldnt we expect not to see Level1 Metric information in both the outputs??? l...@mumbdst1> show isis interface IS-IS interface database: Interface L CirID Level 1 DR Level 2 DR L1/L2 Metric lo0.0 0 0x1 Passive Passive 0/0 xe-0/0/0.0 2 0x1 Disabled Point to Point 100/100000 ge-1/0/0.0 2 0x1 Disabled Point to Point 100/1000 Any thoughts?? Thank you. Regards, JK _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp