I think you might have to reboot both nodes to restore the priority. From: Fahad Khan [mailto:fahad.k...@gmail.com] Sent: Friday, September 17, 2010 11:42 PM To: Harshit Kumar Cc: juniper-nsp@puck.nether.net Subject: Re: [j-nsp] Chassis Cluster - Strange behavior
Yes I can understand, But i need to use the cluster and intend to add the secondary device again to the cluster. I hope it will set to the configured priorities after connecting both devices in the cluster as cold sync or flowd runs at the time of reboot to syc SPUs. regards, Muhammad Fahad Khan JNCIP - M/T # 834 IT Specialist Global Technology Services, IBM fa...@pk.ibm.com<mailto:fa...@pk.ibm.com> +92-301-8247638 Skype: fahad-ibm http://pk.linkedin.com/in/muhammadfahadkhan On Sat, Sep 18, 2010 at 5:14 AM, Harshit Kumar <hars...@juniper.net<mailto:hars...@juniper.net>> wrote: On a single node cluster, priority has no significance. You can safely ignore this. You can move to stand-alone mode if you don't plan to use the cluster. -----Original Message----- From: juniper-nsp-boun...@puck.nether.net<mailto:juniper-nsp-boun...@puck.nether.net> [mailto:juniper-nsp-boun...@puck.nether.net<mailto:juniper-nsp-boun...@puck.nether.net>] On Behalf Of Fahad Khan Sent: Friday, September 17, 2010 8:05 AM To: juniper-nsp@puck.nether.net<mailto:juniper-nsp@puck.nether.net> Subject: [j-nsp] Chassis Cluster - Strange behavior Hi Folks, I have been running SRX3600 In chassis cluster. At the moment, I have disconnected control link and fabric link and Secondary device is isolated from the network. But on primary device, the cluster configs are still there. The network is working fine with primary device but when i see chassis cluster status, i find this SRX3600-A> show chassis cluster status Cluster ID: 1 Node Priority Status Preempt Manual failover Redundancy group: 0 , Failover count: 1 node0 254 primary no no node1 0 lost n/a n/a Redundancy group: 1 , Failover count: 1 node0 0 primary yes no node1 0 lost n/a n/a why I am getting Node0 priority as 0 for red group 1, while i has been set to 254??? have any body experienced????? thanks and regards, Muhammad Fahad Khan JNCIP - M/T # 834 IT Specialist Global Technology Services, IBM fa...@pk.ibm.com<mailto:fa...@pk.ibm.com> +92-301-8247638 Skype: fahad-ibm http://pk.linkedin.com/in/muhammadfahadkhan _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net<mailto:juniper-nsp@puck.nether.net> https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp