Hi Everyone,
I'm trying to get IPv6 up and running on an ADSL2+ pim in an SRX210 without much luck. Hopefully someone has run across this (good or bad). I'm also living life on the edge and am running 11.1R3.5. I was running 10.4R4.5 and can go back to it if anyone thinks that will help. I keep getting "family INET6 not allowed with this encapsulation" on a commit check. I've tried two different encapsulations and the configs look like this: This one has the encapsulation in the unit: show interfaces at-1/0/0 atm-options { vpi 0; } dsl-options { operating-mode adsl2plus; } unit 0 { encapsulation ether-over-atm-llc; vci 0.37; family inet { filter { output bruce-qos; } address xxx.xxx.xxx.xxx/29; } family inet6 { address 2607:xxxx:x::x/126; } } This one has the encapsulation right at the at-1/0/0 level: show interfaces at-1/0/0 encapsulation ethernet-over-atm; atm-options { vpi 0; } dsl-options { operating-mode adsl2plus; } unit 0 { vci 0.37; family inet { filter { output bruce-qos; } address xxx.xxx.xxx.xxx/29; } family inet6 { address 2607:xxxx:x::x/126; } } Has anyone experienced similar behavior? I'd hate to have to go to an external modem to get this to work, or have to use PPPoE. Thanks! Bruce Bruce Buchanan Senior Network Technician Nexicom 5 King St. E., Millbrook, ON, LOA 1GO Phone: 705-932-4147 FAX: 705-932-3027 Cell: 705-750-7705 Web: http://www.nexicom.net Nexicom - Connected. Naturally. _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp