On Wed, Aug 29, 2012 at 08:16:42AM +0200, Robert Hass wrote: > Hi > > I need to transport VLAN (switch / bridge) from port xe-0/0/1 (unit > 200) to port xe-0/0/2 (unit 200) on MX80. > It it possible ? If yes can anyone paste configuration for this task. > Can I enable QinQ for this VLAN also ? > > BTW. I'm running 10.4S10
You can try doing a simple circuit-cross-connect since there are only two local ports involved. I /think/ QinQ should transparently pass through this--just make sure your MTU is large enough. You can also have other units on these same interfaces doing routing or CCC as well. I last used this on M-series ca. 8.5, so YMMV on MX80 and more modern code. interfaces { xe-0/0/1 { description A; mtu 1600; vlan-tagging; encapsulation flexible-ethernet-services; unit 200 { encapsulation vlan-ccc; vlan-id 200; family ccc; } } xe-0/0/2 { description B; mtu 1600; vlan-tagging; encapsulation flexible-ethernet-services; unit 200 { encapsulation vlan-ccc; vlan-id 200; family ccc; } } } protocols { connections { interface-switch A-CCC-B { interface xe-0/0/1.200; interface xe-0/0/2.200; } } mpls { interface all; interface fxp0.0 { disable; } } } _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp